It will need some room to be able to screw the cleanout adapter onto the trap adapter that sits atop the bottom shaft. Drill a 3 inch hole at that spot so that the cleanout adapter on the top piece sits easily inside the opening. You will need to determine where the neck of the water bottle will be on the platform of the bracket. Once those two are in place, cement the left and right side horizontal beam making sure that the cups are lined up and that the cups sit flat so that water doesn't spill out easily. On the outside end of each beam, install the 1/2" adapters and screw on the plug using the joint compound.Īdd the other two 1/2" adapters to the bushings on the left and right side of the tee using joint compound. Repeat these steps to construct the other side of the beam. Make sure to line up the cups so they are straight. The next piece will be another cup coupler, followed by another 3" piece of pipe. Next, add the 6 inch piece to the other end of the cup coupler. I chose to order the ones with the 1/2" PVC couplers, but they have other ways to add them to your system. Start with a 3" piece of 1/2" pipe and glue one of the Beaktime cup couplers. UGH! We will try to make it with this one picture and a bunch of verbiage. Well, in the hurry of trying to get this together before the kids needed to be run here and there for sports practices, I forgot to take the detailed pictures of the construction of the horizontal beams that I had planned.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |